Out she comes.
Initially I thought I would sand and put coats of anti-foul on.
Plans changed and I ended up stripping her right back.
First coat of PR250 Primer
Port side, I like this colour.
First coat of primer PR250
Starboard side
First coat of epoxy tie coat - port side.
Top sides filled and ready to sand.
Top coat of red anti-foul done , topsides filler and ready to sand.
One coat of enamel on port top side - final red coat of anti-foul.
Shiny :-)
Prop clearance is 65 - 70 mm will an anode fit here?
For anode research.
Prop anode does fit. Needed the split pin holes exntended with 4mm drill and hack saw. All good :-)
4mm clearance - all ok as shaft does not move aft at all.
Bottom ruder bracket anode 600g (I think) in place.
Prop anode - 4mm clearance and top rudder bracket and shaft anode (1kg).
Bow: finished and ready for launch
Port side - finished
Starboard - finished
Love this view - nice and clean :-)
Looking clean and shiny.
Re-launch